I don't know why but just the other day I moved the knob to check the bias readings and the pointer was nowhere to be seen. I looked hard and saw it way off to the side. So, I checked the wiring and all looks good there. Everything seems to be as it should be. I have not checked if there is voltage going to the meter and I will do that tomorrow.
Worst case Scenario. If the meter is dead what are my options? Of course if I can get one from JM or elsewhere would be best. If none is available is it repairable? What about installing a test jack and just using the input to the meter on the test jack, then use my DVM to make the readings? Any help will be appreciated. Thank you , Dak
This post is made possible by the generous support of people like you and our sponsors:
Topic - My HK Citation2 meter quit working - DAK 21:52:12 06/09/15 (10)
- RE: My HK Citation2 meter quit working - AJ 10:15:54 06/10/15 (9)
- RE: My HK Citation2 meter quit working - elflow 12:51:56 06/10/15 (0)
- RE: My HK Citation2 meter quit working - DAK 11:16:41 06/10/15 (7)
- RE: My HK Citation2 meter quit working - Jim McShane 18:12:32 06/14/15 (4)
- RE: My HK Citation2 meter quit working - DAK 21:21:53 06/14/15 (3)
- RE: My HK Citation2 meter quit working - Jim McShane 15:36:22 06/15/15 (2)
- RE: My HK Citation2 meter quit working - DAK 10:31:41 06/18/15 (1)
- RE: My HK Citation2 meter quit working - Jim McShane 13:40:07 06/18/15 (0)
- RE: My HK Citation2 meter quit working - Tre' 15:26:49 06/10/15 (1)
- RE: My HK Citation2 meter quit working - DAK 17:01:04 06/10/15 (0)