In Reply to: RE: Schottky diodes posted by Caucasian Blackplate on June 3, 2015 at 22:04:50:
"What filaments? You'd want a very different Schottky diode to heat a 45 than, say, a 2A3"
Oh goodness, I've heard that schottky's were susceptible to blowing at turn on/in-rush. I just thought as long as the amperage was high and the voltage not to high about 600v then I'd be good to go.
Have gone and used Cree C3D04060 For my 6SN7 bridge here?
I'd like some suggestions for my 300B filaments...
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Schottky diodes - mashley 05:21:40 06/04/15 (7)
- RE: Schottky diodes - Caucasian Blackplate 09:36:23 06/04/15 (6)
- RE: Schottky diodes - mashley 15:45:18 06/08/15 (2)
- RE: Schottky diodes - Caucasian Blackplate 08:19:06 06/09/15 (1)
- RE: Schottky diodes - mashley 22:07:28 06/09/15 (0)
- RE: Schottky diodes - mashley 12:31:02 06/05/15 (2)
- RE: Schottky diodes - Caucasian Blackplate 12:32:17 06/05/15 (1)
- RE: Schottky diodes - mashley 08:03:45 06/07/15 (0)