|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Schottky diodes posted by lovetube on June 3, 2015 at 18:15:23:
Well, I guess you'd go on Mouser or Digikey and select for low voltage high current types that exceed the needed parameters by a healthy margin. That's what I did, when I changed over to Schottkys from Hexfreds for my preamplifier filament supply, which is also voltage-regulated. Sort of like the OP, I couldn't figure out why I had too little V for proper regulation, until I made the swap.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Schottky diodes - Lew 21:22:24 06/03/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
