I decided I was tired of messing with the usual chassis materials and bought a 12U rack to build something like what I've seen in some old tube transmitters.
Hammond 1650R outputs, KT120 tubes, EL84 drivers, using the E-linear topology by Douglas.
Lots of work left to do... filament wiring, CCS for the drivers/phase splitter tubes...
Power supply is dual mono choke input, 1H 12 ohms dcr, followed by 240uf of capacitance that are GE oilers.. if I can fit more C in there I will yet.
I am a bit concerned about the lack of filtering given the front end runs off of the UL taps. I've considered adding a bunch of capacitance or another LC stage. I've got another pair of 1H chokes on hand I might put in.
The power transformers are TWO Antek 4T360 toroids in paralell into a Cree Schottky bridge.
Always welcome suggestions from this group! This has been a fun albeit slow build.
When done the DC2a3 amp goes back on the bench for more fun.
This post is made possible by the generous support of people like you and our sponsors:
Topic - PP amp build - rage 09:02:22 05/11/15 (9)
- RE: PP amp build - deathtube 667 16:24:01 05/12/15 (1)
- RE: PP amp build - rage 03:54:56 05/13/15 (0)
- RE: PP amp build - PakProtector 15:18:58 05/11/15 (0)
- RE: PP amp build - Caucasian Blackplate 09:19:56 05/11/15 (5)
- RE: PP amp build - Tre' 10:04:48 05/11/15 (4)
- RE: PP amp build - Caucasian Blackplate 10:11:27 05/11/15 (3)
- RE: PP amp build - rage 10:31:34 05/11/15 (2)
- RE: PP amp build - Caucasian Blackplate 10:47:44 05/11/15 (1)
- RE: PP amp build - rage 10:58:41 05/11/15 (0)