In Reply to: 91A debugging problems.... posted by vinnie2 on April 18, 2015 at 11:38:44:
Ok, found another problem; I had the center tap on the 5v winding for the 5ar4 grounded and it should not have been. Took that off and I am now getting B+.
I am using a hammond 278x power tranny rated at 400-0-400, so if I put a probe on each plate of the 5ar4 should I read close to 800 vac or 400 vac?
I stopped before I got to full power, but I was at 600+ vac with a probe on each 5ar4 plate with a B+ of 330 vdc. It looks like if I were at 800 vac on the plates I would be close to the 400+ vdc I am supposed to have for B+.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- update 2 - vinnie2 07:43:53 04/19/15 (4)
- RE: update 2 - Tre' 10:47:25 04/19/15 (3)
- RE: update 2 - vinnie2 12:01:52 04/19/15 (2)
- RE: update 2 - Tre' 12:30:24 04/19/15 (1)
- RE: update 2 - vinnie2 12:55:31 04/19/15 (0)