In Reply to: SEP 6L6G posted by hifipaul on April 2, 2015 at 15:46:53:
Guys:
Thank you for your comments and help. The need for adequate gain became very important as feedback was applied. The selected gain tube is a 7f7. The circuit is similar to the RH design.
Some years ago I modified a ST70 to take just about every output tube with a 6l6 type pin out. I found the 6l6g to have the most compelling midrange of all of them; and that proved to be true here again. Note all of the tubes in the pic.
Surprises: All of the 6l6s sounded at least good. The Soveteks were way better than I expected. RCA 6L6GBs (black plates) had the best balance top to bottom, really not a surprise though.
I am now into the Frack with it stage. The feedback needs to be dialed in, parts selection, and I need to decipher of a cathode follower is needed between stages (as in the RH schematic).
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: SEP 6L6G - hifipaul 08:03:25 04/09/15 (4)
- RE: SEP 6L6G - Alex Kitic 23:54:00 04/14/15 (1)
- RE: SEP 6L6G - hifipaul 09:56:29 04/15/15 (0)
- RE: SEP 6L6G - Al Noakes 08:15:58 04/09/15 (1)
- RE: SEP 6L6G - hifipaul 10:33:07 04/09/15 (0)