Home Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

RE: Blown resistors

You need a 100ohm linear taper pot. Any type will work, but I would use a mil.spec. wirewound. Pin 9 is the plate and pin 1 is grid 2.
6973 data sheet is attached.

.
Freak out...Far out...In out....


This post is made possible by the generous support of people like you and our sponsors:
  Parts Connexion  


Follow Ups Full Thread
Follow Ups
  • RE: Blown resistors - dee eye why 12:39:40 04/05/15 (0)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.