|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Blown resistors posted by onthethreshold1 on April 4, 2015 at 14:43:39:
Looks like part of a cathode bias circuit with finals balancing facilities (pot). If the resistors fried like this AND a fuse blew, the pot is suspect too. Also, an opinion is that if lack of a load caused all this damage, something is fundamentally deficient with the amp design and/or implementation. i.e. A well designed amp in good repair should be able to tolerate a no-load condition at this relative low power level w/o damage.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Blown resistors - Steve O 15:30:58 04/04/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
