In Reply to: RE: Making some progress on my new project posted by deafbykhorns on March 26, 2015 at 17:01:23:
Dan said it was good with him to show the schematic so here it is. I did the filament supply a bit differently from Dan's drawing as per what Rod Coleman suggested and being that I used his regulator for the 300B I did as he suggested. It probably accomplished the same thing using Dan's idea there.
Just note that the chokes(BAC 80) and output trannys(EXO-050) cost me almost $1400 two years ago.
With all the parts and chassis along with the tubes(especially the 300B's) this amp is not going to be cheap. With everything I have accomplished without labor I am into this thing for over $2000 in parts alone and I'm not done. But that's with the power supply chassis included. I will post a picture or two of it soon.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Making some progress on my new project - xaudiomanx 03:01:40 03/27/15 (1)
- RE: Making some progress on my new project - mqracing 08:54:23 03/29/15 (0)