|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: And yet ... posted by DAK on March 25, 2015 at 00:38:23:
that's just me. Note that I said I run inrush current limiters these days and have done for years. The few tenths of a volt drop under normal operating conditions keeps all of my filaments well within spec even under elevated mains voltage conditions.
So, to clarify my response to the initial poster's question I don't think anything needs to be done to the rest of the amp to cater for slightly higher mains voltage but I would still add a few cheap inrush current limiters to the filaments.
I would of course check the ratings of caps and the like but I'd be surprised if anything needed to be done in that respect.
Naz
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I've done lot's of things to test the limits ... - Naz 03:15:43 03/25/15 (1)
- RE: I've done lot's of things to test the limits ... - DAK 12:58:06 03/25/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
