The schematic calls for a 750vct tranny, and then a pi filter with a 10 hry choke. Certainly not fashionable and low dcr.
I have these parts.
I also have a formidable 900vct tranny and a boat anchor 3.3 hry choke, about 27 ohm dcr for choke input.
I'm not sure how to finish this supply.
Thought maybe split into two rails with a 2 smaller chokes like the Dyna c-354 (where I have one) and caps of course.
We also have the "flywheel" arrangement and various offspring.
Could use some sensible ideas on how to proceed.
Thanks
This post is made possible by the generous support of people like you and our sponsors:
Topic - Morrison Micro Power Supply - wclarson12 17:10:09 02/24/15 (4)
- RE: Morrison Micro Power Supply - larrymoore@ultrafi.biz 05:15:35 02/25/15 (1)
- Very Good (nt) - drlowmu 06:21:42 02/25/15 (0)
- RE: Morrison Micro Power Supply - Paul Joppa 17:46:36 02/24/15 (1)
- AMEN (nt) - danlaudionut 07:59:11 02/25/15 (0)