In Reply to: RE: Brook 12A plate load choke? posted by thermionic addictions on January 21, 2015 at 15:58:34:
They seemed very nice, but I was a little put off by the fact that they dismissed my measurements and my question as to whether or not this was an appropriate replacement, not to mention the fact that, now, I've got to call my customer with the bad news, announce a delay, and revise the estimate.
Just to check my methodology, I confirmed my readings with a second bridge and ran the same test on the primary of a Deluxe Reverb OPT I had handy. I got virtually identical L readings from the center tap of the primary to either end.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Brook 12A plate load choke? - Thermionic27609 17:49:39 01/21/15 (0)