|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Too Much Sand! posted by Triode_Kingdom on January 20, 2015 at 13:04:32:
I was very anti-solid state, but as Eli says, it is just a tool for a job. Like using a diode for the negative part of a full wave rectifier bridge or a diode in a a bias supply. The MOSFET as a source follower can do amazing things for very little money and is better sounding than the other options.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- You really should give it a try - Chip647 05:04:37 01/21/15 (1)
- RE: You really should give it a try - Michael Samra 07:53:45 01/21/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
