|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
Hello again!
I'm also on the lookout for a tube driver interstage, around 5K 1:1 SE interstage gapped for up to 40-50mA... Any tips? I found the Hammond 126B, but only rated at 30mA, and the electra-print 3033 is a bit over budget. Edcor does not seem to offer interstages.
Suggestions welcomed, thanks!
Joris
This post is made possible by the generous support of people like you and our sponsors:
Topic - Suggestions for SE interstages on a budget? - jorisdallaire 20:31:03 01/19/15 (11)
- If you are on a budget and need current - Ralph 10:18:56 01/20/15 (0)
- Are you shooting for A2? - Chip647 04:39:42 01/20/15 (7)
- RE: Are you shooting for A2? - jorisdallaire 06:04:06 01/20/15 (6)
- RE: Are you shooting for A2? - Eli Duttman 11:14:42 01/20/15 (5)
- Too Much Sand! - Triode_Kingdom 13:04:32 01/20/15 (4)
- You really should give it a try - Chip647 05:04:37 01/21/15 (1)
- RE: You really should give it a try - Michael Samra 07:53:45 01/21/15 (0)
- RE: Too Much Sand! - Eli Duttman 20:32:24 01/20/15 (1)
- am still looking for a job as lamplighter but powerdrive is um powerful-nT - Cleantimestream 03:39:19 01/21/15 (0)
- am sorry Sir, there is no 'budget' interstage ... unless you count Electraprint-nT - Cleantimestream 03:06:38 01/20/15 (1)
- I am beginning to realize that... :-( [nt] - jorisdallaire 06:04:42 01/20/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
