In Reply to: RE: Garg0yle 2A3 DC posted by rage on January 19, 2015 at 12:17:38:
The chokes I am using are 7.5H and 110 ohms /160ma per channel. Somewhat similar though to the BB-proof, just a little more induction and a little less resistance then the specified Hammond which has a lot more availability.
The drawing takes a little getting used too, but if you look at the other side of the schematic you will see is effectively reservoir capacitors.
That "second" capacitor is split, the top half being the "ultrapath" that terminates at the cathode of the 2A3 above the resistor, as opposed to being terminated to ground below cathode resistor as in more traditional setups. (Like the 6J5)
△This message will self destruct in 10 seconds△
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Garg0yle 2A3 DC - Garg0yle 12:32:41 01/19/15 (17)
- RE: Garg0yle 2A3 DC - thermionic addictions 14:40:11 01/19/15 (1)
- RE: Garg0yle 2A3 DC - Garg0yle 16:42:51 01/19/15 (0)
- RE: Garg0yle 2A3 DC - Al Noakes 14:10:36 01/19/15 (13)
- RE: Garg0yle 2A3 DC - Garg0yle 16:38:39 01/19/15 (12)
- RE: Garg0yle 2A3 DC - Al Noakes 00:46:06 01/20/15 (11)
- RE: Garg0yle 2A3 DC - drlowmu 06:36:56 01/20/15 (10)
- RE: Garg0yle 2A3 DC - Al Noakes 09:14:31 01/20/15 (9)
- RE: Garg0yle 2A3 DC - Garg0yle 12:19:10 01/20/15 (8)
- RE: Garg0yle 2A3 DC - Al Noakes 13:42:29 01/20/15 (1)
- RE: Garg0yle 2A3 DC - Garg0yle 14:47:28 01/20/15 (0)
- RE: Garg0yle 2A3 DC - rage 13:07:46 01/20/15 (5)
- RE: Garg0yle 2A3 DC - Garg0yle 18:44:10 01/21/15 (4)
- RE: Garg0yle 2A3 DC - rage 07:57:56 01/22/15 (3)
- RE: Garg0yle 2A3 DC - Garg0yle 08:46:27 01/22/15 (2)
- RE: Garg0yle 2A3 DC - rage 08:47:32 01/22/15 (1)
- RE: Garg0yle 2A3 DC - Garg0yle 13:26:44 07/28/15 (0)
- RE: Garg0yle 2A3 DC - rage 12:44:10 01/19/15 (0)