|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: It's Cary indeed. posted by drlowmu on December 18, 2014 at 12:28:23:
Perhaps my non-engineer perception of ripple is causing mis-communication. The "ripple" I mentioned was actually the voltage drop from peak to that at start of next charge cycle.
I have looked up datasheets of DC Link caps. They are too large to be used as drop-in replacement, being 85 mm in diameter & the existing caps are of 51 mm.
I agree that 600 uF maybe too large, but what would be the appropriate replacement value?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: It's Cary indeed. - ianm0 14:18:06 12/18/14 (12)
- RE: It's Cary indeed. - drlowmu 16:32:37 12/18/14 (11)
- Mike's goal with that Cary is a bit different than yours... - Steve O 21:32:44 12/18/14 (5)
- Look at the schematic he posted.... - drlowmu 08:50:54 12/19/14 (3)
- Quoting from your msg I was responding to.... - Steve O 12:57:59 12/19/14 (2)
- RE: Quoting from your msg I was responding to.... - drlowmu 13:37:50 12/19/14 (1)
- And season's best to you! (nt) - Steve O 15:26:04 12/19/14 (0)
- RE: Mike's goal with that Cary is a bit different than yours... - Eli Duttman 07:52:22 12/19/14 (0)
- RE: It's Cary indeed. - ianm0 19:56:24 12/18/14 (4)
- RE: It's Cary indeed. - drlowmu 09:10:44 12/19/14 (3)
- RE: It's Cary indeed. - ianm0 17:54:21 12/19/14 (2)
- RE: It's Cary indeed. - drlowmu 19:42:16 12/19/14 (1)
- RE: It's Cary indeed. - ianm0 16:34:17 12/25/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
