|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Guitar Amp Prototype posted by Triode_Kingdom on December 14, 2014 at 16:08:35:
To what Fender said, you will likely end up with a guitar preamp on front of this as it is likely super clean and a bit dark. You have an extra unused 6SL7 section. Add a switch and use that section with a 300k plate load channel and a 0.001 coupling cap. This will leave your circuit stock until you throw the switch and it becomes more rock and roll.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Guitar Amp Prototype - Chip647 05:11:28 12/15/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
