RE: I think I know where the error might be.

Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

Posted by Michael Samra (D) on November 24, 2014 at 10:18:08

In Reply to: RE: I think I know where the error might be. posted by vinnie2 on November 24, 2014 at 10:00:38:

I just read what Ralph wrote and yes,I am saying the same thing.The 6SL7 will not conduct unless you have a cathode resistor going to ground which in this case is also a feedback resistor. If you want to eliminate the FB loop for shits and giggles,just ground the 1k resistor on the side going to the transformer secondary after you disconnect it from the secondary of course.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - puzzled part deux - vinnie2 05:41:57 11/24/14 (13)

update - vinnie2 11:21:08 11/24/14 (0)

I think I know where the error might be. - Michael Samra 09:46:20 11/24/14 (2)

RE: I think I know where the error might be. - vinnie2 10:00:38 11/24/14 (1)

RE: I think I know where the error might be. - Michael Samra 10:18:08 11/24/14 (0)

Uh, did you notice that when you disconnected the feedback - Ralph 08:35:45 11/24/14 (5)

RE: Uh, did you notice that when you disconnected the feedback - vinnie2 09:54:18 11/24/14 (2)

RE: Uh, did you notice that when you disconnected the feedback - David Smith 11:01:17 11/24/14 (0)

RE: Uh, did you notice that when you disconnected the feedback - rage 10:01:34 11/24/14 (0)

RE: Uh, did you notice that when you disconnected the feedback - vinnie2 09:51:04 11/24/14 (1)

From the cathode of the 6SL7 to ground. - Ralph 11:25:50 11/24/14 (0)

RE: puzzled part deux - SteveBrown 08:21:36 11/24/14 (0)

You can do this yourself - Triode_Kingdom 07:07:54 11/24/14 (1)

RE: You can do this yourself - vinnie2 07:11:22 11/24/14 (0)

Follow Ups

RE: I think I know where the error might be. - Michael Samra 10:18:08 11/24/14 (0)

Post a Message!