|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: puzzled part deux posted by vinnie2 on November 24, 2014 at 05:41:57:
You only need to look up the typical operating conditions shown in the datasheets. That will tell you what voltages to expect and how much current should be flowing through the tubes. If it's distorted, you'll likely find a voltage or current that's way off. It won't be a subtle difference.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- You can do this yourself - Triode_Kingdom 07:07:54 11/24/14 (1)
- RE: You can do this yourself - vinnie2 07:11:22 11/24/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
