|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: SPICE Directive posted by Triode_Kingdom on November 13, 2014 at 19:50:16:
Also, the default unit of measurement for LTSPICE inductors is the Henry. This is true whether the inductor is a choke or a transformer winding coupled to another winding. When the inductor is a transformer winding, the ratio between coupled windings is expressed by assigning them specific values of inductance. The assigned inductance ratio acts similarly to ratios of impedance. In other words, a transformer with an 8K primary Z and 800 ohm secondary Z can be simulated with a 10H primary and 1H secondary. This ratio will relate to the turns ratio (voltage ratio) in the same way as any transformer.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- More... - Triode_Kingdom 20:32:26 11/13/14 (2)
- RE: Wow, that was easier than I thought - deafbykhorns 05:50:44 11/15/14 (1)
- Yes to both (nt) - Triode_Kingdom 10:49:12 11/15/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
