In Reply to: 211 Build posted by deafbykhorns on November 7, 2014 at 16:42:05:
Ok, after running a 211 thru SE CAD, it seems the most I can get out of that tube without too much distortion is 18watts.
Would everyone agree? Seems the grid starts going pos at just over 50 volts.
After about 75 volts, the distortion is probably unacceptable which is around 25 watts.
A 10K OPT seems to have much lower distortion but I was thinking about a compromise and try 7K.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: New direction - deafbykhorns 17:35:01 11/08/14 (15)
- RE: New direction - Paul Joppa 15:34:21 11/09/14 (0)
- RE: New direction - drlowmu 19:30:17 11/08/14 (3)
- RE: I don't have that article but - deafbykhorns 04:42:59 11/09/14 (2)
- RE: I don't have that article but - PakProtector 19:24:54 11/09/14 (0)
- RE: I don't have that article but - drlowmu 07:15:57 11/09/14 (0)
- RE: New direction - Triode_Kingdom 17:59:49 11/08/14 (9)
- RE: Sounds like you've been around the block a couple times - deafbykhorns 05:37:05 11/09/14 (0)
- RE: I like the simplicity-Hows the bandwidth? - deafbykhorns 19:17:40 11/08/14 (7)
- RE: I like the simplicity-Hows the bandwidth? - Triode_Kingdom 13:07:47 11/09/14 (2)
- 211 Pre-Driver - Triode_Kingdom 15:35:00 11/09/14 (0)
- RE: Thank you for the followup,like your filament supply - deafbykhorns 15:13:20 11/09/14 (0)
- Not so simple - drlowmu 11:35:25 11/09/14 (3)
- You're wrong as usual - Triode_Kingdom 13:15:42 11/09/14 (2)
- RE: You're wrong as usual - PakProtector 14:44:37 11/09/14 (1)
- RE: You're wrong as usual - Triode_Kingdom 14:58:09 11/09/14 (0)