|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: A/B testing set up...... posted by vinnie2 on October 23, 2014 at 05:42:04:
I have some 10 ohm 30 watt resistors that I can tie across the outputs of each amp. It would then only take a split second to switch amps with the switch I will use, and the amp that wasn't playing would have a 10 ohm load on it. Is that split second likely to be a problem?
I already tried putting one across the outputs of the 845 amp, and the only difference I could hear was a little less volume. I can correct for that at the line stage.
Is this likely to effect the sound of the amps? Have I missed anything else?
Edits: 10/23/14
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- How would this work? - vinnie2 13:20:33 10/23/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
