Hello to all!
Currently building a current-regulated supply for the heater of a DHT.
The spec is 1A/6.3V. However if i run it with 1A, the drop accros the heater is 8.5V.
Ok i say, so the spec is incorrect, and i can adjust the current easly. But what is the most important parameter, the right current or the right voltage on the heater? Or the right power?
My guess is that i should not go over the voltage spec, but then the current is down at 750mA. Will that suffice for correct operation?
Thank you in advance.
Joris
This post is made possible by the generous support of people like you and our sponsors:
Topic - DHT heater specs. - jorisdallaire 18:47:33 10/17/14 (7)
- RE: DHT heater specs. - Tre' 23:21:51 10/17/14 (1)
- I was operating from memory.... - jorisdallaire 23:39:57 10/17/14 (0)
- RE: DHT heater specs. - Caucasian Blackplate 22:12:31 10/17/14 (3)
- RE: DHT heater specs. - jorisdallaire 23:06:50 10/17/14 (2)
- RE: DHT heater specs. - Paul Joppa 16:34:29 10/18/14 (1)
- Cute indeed! - jorisdallaire 12:35:59 10/19/14 (0)
- Answer.... - jorisdallaire 20:52:44 10/17/14 (0)