In Reply to: RE: Al is on the money ... posted by jazbo8 on October 16, 2014 at 10:56:37:
The whole point of filament bias is that the plate current AND the filament (heater in this case) current is flowing through the resistor so the resistor does not need to be very large so very little local current feedback will exist and there will not be a need to bypass it.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Al is on the money ... - Tre' 11:05:23 10/16/14 (0)