In Reply to: RE: What tubes is this Electraprint? SE OPT designed for? posted by Chip647 on October 16, 2014 at 05:11:19:
Hi Chip, I used that method and measured about 12vac to 1v on the secondaries. Squaring that gives 144 x 8ohm is 1.2k reflected impedance. I am assuming that the taps are 4 and 8 ohm in the secondary. regards, Dak
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: What tubes is this Electraprint? SE OPT designed for? - DAK 09:09:46 10/16/14 (4)
- What if they're 8 and 16 ohms? - Tre' 10:42:01 10/16/14 (3)