RE: Then you need to adjust your parts values

Posted by Thomas Mayer (M) on September 18, 2014 at 03:04:42

In Reply to: RE: Then you need to adjust your parts values posted by chrismercurio on September 17, 2014 at 10:56:24:

Hi!

For preamp voltages you will not have issues with buzz from the plate chokes.

>>> Do you think it's worthwhile to make separate legs for left and right? Or it's not important especially if it's all in a single chassis? <<<<

See my post above, this heavily depends on your circuit (PSRR).
I usually feed each channel and each stage with a separate RC or LC leg

Thomas

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Separate LC legs LR Preamp Supply - chrismercurio 14:17:39 09/14/14 (15)

RE: Separate LC legs LR Preamp Supply - Thomas Mayer 07:25:04 09/15/14 (0)

RE: Separate LC legs LR Preamp Supply - twystd 22:21:19 09/14/14 (0)

RE: Separate LC legs LR Preamp Supply - chrismercurio 18:34:07 09/14/14 (10)

Then you need to adjust your parts values - Chip647 05:18:58 09/15/14 (9)

RE: Then you need to adjust your parts values - mobiasloop 09:07:54 09/15/14 (8)

RE: Then you need to adjust your parts values - chrismercurio 12:34:48 09/15/14 (7)

RE: Then you need to adjust your parts values - Thomas Mayer 00:31:06 09/16/14 (2)

RE: Then you need to adjust your parts values - chrismercurio 10:56:24 09/17/14 (1)

RE: Then you need to adjust your parts values - Thomas Mayer 03:04:42 09/18/14 (0)

RE: Then you need to adjust your parts values - Triode_Kingdom 16:59:18 09/15/14 (2)

RE: Then you need to adjust your parts values - chrismercurio 19:51:16 09/15/14 (1)

PS Design - Triode_Kingdom 22:29:02 09/15/14 (0)

RE: Then you need to adjust your parts values - mobiasloop 16:15:44 09/15/14 (0)

Less is better than more - Chip647 17:22:11 09/14/14 (0)

RE: Separate LC legs LR Preamp Supply - Caucasian Blackplate 15:16:42 09/14/14 (0)

Follow Ups

RE: Then you need to adjust your parts values - Thomas Mayer 03:04:42 09/18/14 (0)

RE: Then you need to adjust your parts values

Post a Message!