Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Tube DIY Asylum ]

---

[ Alert Moderator ]

---

RE: Have I got this right?

Posted by Tre' (P) on September 16, 2014 at 15:38:32

In Reply to: Have I got this right? posted by vinnie2 on September 16, 2014 at 14:12:38:

65ma is the max for the 6bq5 but yes, if you want to parallel 2 tubes then there will be twice as much current as one if you want to run each tube the same as you were running the one. Twice the current, half the plate resistance and half the load impedance.

If you want 4 output tubes in parallel then there will be 4 times the current than just one.

Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"

This post is made possible by the generous support of people like you and our sponsors:

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---