Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Tube DIY Asylum ]

---

[ Alert Moderator ]

---

RE: The Quiz of today???

Posted by Tre' (P) on September 16, 2014 at 13:25:12

In Reply to: The Quiz of today??? posted by TomWh on September 16, 2014 at 13:09:35:

"So it turned out to be the filament trans"

I'm not sure what you mean.

Is the heater voltage high or low on the side that is drawing more current?

I will guess high.

So yes, if the heater voltage is too high or too low it will change the current through the tube and thus change the plate voltage.

Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"

This post is made possible by the generous support of people like you and our sponsors:

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---