Ok to not make this is a really long story I built separate channel for left right buffer gain each completely separate from each other. (6j5 trans output for a dac) So I was checking b+ and current and the one side was around 25 volts higher than the other and the current was higher on the lower B+ side (which makes sense) So I checked caps, dampers, chokes etc etc etc.
So it turned out to be the filament trans I used on the 6j5 where 269ex hammonds which I had and they have b+ voltage which I left idle. How could this cause a voltage drop in the circuit like this???
Thanks Tom
This post is made possible by the generous support of people like you and our sponsors:
Topic - The Quiz of today??? - TomWh 13:09:35 09/16/14 (5)
- RE: The Quiz of today??? - Tre' 13:25:12 09/16/14 (4)
- RE: The Quiz of today??? - TomWh 13:47:18 09/16/14 (3)
- RE: The Quiz of today??? - Tre' 15:34:08 09/16/14 (2)
- RE: The Quiz of today??? - TomWh 16:18:44 09/16/14 (1)
- RE: The Quiz of today??? - Tre' 16:33:29 09/16/14 (0)