In Reply to: RE: If you want to create a balanced output from your phono section posted by backendloaded on September 10, 2014 at 08:23:31:
The purpose of a balanced connection is to reject hum (usually in long runs).
If you don't have a hum problem (and you shouldn't between the output of a phono pre and the input of a line stage) then un-balancing one balanced input on your line stage should work just fine.
This is how you do that, connect the output of single ended phono preamp stage to pin 2, circuit ground to pin 3 and pin 1. Done!
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: If you want to create a balanced output from your phono section - Tre' 11:28:02 09/10/14 (0)