In Reply to: RE: rca to xlr posted by backendloaded on September 10, 2014 at 05:44:43:
Thank you all for your help! I need to clarify. I am building a tube phono amplifier. I would like to make it XLR out to connect to my pre amp. From what I have read I only need to use a female XLR connector and hook it with pin 1 chassis ground, pin 2 +, pin 3 -? I also have the chassis grounded to house and circuit. Would this be the best way? Also I have a dumb question that will help me tie this all together. Is a balanced signal just a single ended signal with the chassis grounded? I am confused as I thought that a balanced signal was different. Thanks you.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: rca to xlr - backendloaded 07:59:00 09/10/14 (4)
- If you want to create a balanced output from your phono section - Ralph 08:13:27 09/10/14 (3)
- RE: If you want to create a balanced output from your phono section - backendloaded 08:23:31 09/10/14 (2)
- RE: If you want to create a balanced output from your phono section - Tre' 11:28:02 09/10/14 (0)
- RE: If you want to create a balanced output from your phono section - Ralph 08:40:24 09/10/14 (0)