In Reply to: TO-220 tab leaking to heatsink? posted by jorisdallaire on September 5, 2014 at 08:48:28:
Drilling a small undercut at the top of the tapped hole solved the problem.
Now the shoulder washer inserts into it and everything is kept centered and isolated (no measured resistance at all between tab and heatsink). I didn't add thermal paste, and readings with an infrared meter show a slightly better heatsinking performance... As was mentioned.
I'll never know if the paste was leaking, but who cares... I might not ever use it again anyways. I won't miss this messy stuff.
Thank you for all the suggestions and advice. You guys rock!
Joris
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Problem solved. - jorisdallaire 20:46:35 09/07/14 (0)