hi,
In my amp I have a 50ohm resistor between the power trans CT and the first cap in the LCLC filter. The amp draws 100ma, so the CT is biased -5V with respect to ground.
I want to try using this negative voltage to bias the grid of the input/driver valve, which needs around -3V. After my research on past posts in the forum on various bias methods, I believe this is called back bias.
may I ask for some directions on how best to apply this bias scheme? a schematic would be great help.
thanks!
This post is made possible by the generous support of people like you and our sponsors:
Topic - back bias - Vincin 20:57:48 07/31/14 (5)
- RE: back bias - Tre' 19:29:35 08/01/14 (0)
- RE: back bias - Paul Joppa 19:14:27 08/01/14 (0)
- RE: back bias - Palustris 10:22:51 08/01/14 (0)
- RE: back bias - tubular.well 23:27:52 07/31/14 (1)
- Agree - Triode_Kingdom 06:57:26 08/01/14 (0)