|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: CT Grid Choke Phase Inverter posted by Tre' on July 15, 2014 at 17:06:20:
I tried a design for a phase-inverting center-tapped secondary transformer driven by a single-ended cathode follower, and found it hard to get good balance at high frequencies (above a few kHz) between the two ends of the secondary. This is probably something you should measure with the transformers you are using.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: CT Grid Choke Phase Inverter - TimFox 14:26:52 07/16/14 (1)
- Measurement - FlaCharlie 06:15:44 07/17/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
