|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Golden tube audio SE-40 rebuild posted by Michael Samra on April 18, 2014 at 13:31:20:
Main issue I had was that the resistors would arc to the surface plane on the boards , right through the resistor insulation.I cured issue by heating the solder pads and pushing the resistor leads slightly up sp that there was a slight air gap to the boards.
YMMV
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Golden tube issue - unclestu 14:21:34 04/18/14 (4)
- RE: Golden tube issue - lovetube 22:40:52 04/18/14 (3)
- RE: Golden tube issue - Michael Samra 22:11:06 04/20/14 (2)
- RE: Golden tube SE40 inside photos - lovetube 22:54:24 04/20/14 (1)
- RE: Golden tube SE40 inside photos - pjfarano@outlook.com 12:15:24 08/19/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
