In Reply to: RE: starved filaments posted by GSH on April 10, 2014 at 20:37:23:
I use DC filaments on 2A3 finals. Non-regulated and I had previously used a rheostat bypassed with a power resistor for voltage control.
I'll need to try to set that up again to run the starved filament test.
When I ran the FFT bandwidth sweeps with white noise input and , I noticed that there was a big spike at 120 cycles that went up and down more than +/-5dB.
At 120 cycle spike was a big lower using pink noise.
Perhaps I don't have enough filtering for a stereo circuit or some other reasons.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: starved filaments - deathtube 667 03:44:55 04/11/14 (0)