In Reply to: RE: Magnavox Rebuilds and Fultons (longish) posted by Michael Samra on April 6, 2014 at 15:40:55:
Mike,
Sorry, my RTR/FMI tweeters are not leaving my house until I either die or go deaf. The Fulton version only runs from 5K up but most instruments and voices image at the height of the tweeters.
The 100s run full-range since the lowered position (only few inches off floor) and limited treble dispersion of the Peerless mid-tweeters effectively low-passes the main speakers.
I use RCA 6CG7s in my PP amp for the front end. Not knowing any better, I just followed an old Williamson schematic (I will try to find it for Fitero) with 47K plate and 470R cathode resistor on the first stage, direct coupled first-stage plate to second-stage grid, 22K above and below the second stage. Then second-stage plate and cathode cap-coupled to output tube grids (no third driver stage, unlike Williamson) with 0.1 µF Dynamicaps, 220K to ground. It sounded very nice to me so I have not altered the topology since then (about 2 years ago.) No doubt it could be tweaked more. I only use 4-6 dB of feedback so it is enough gain.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Magnavox Rebuilds and Fultons (longish) - JJ Triode 16:55:16 04/07/14 (0)