|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: High transconductance tubes sound as transistors... posted by Tre' on March 30, 2014 at 08:19:44:
If you are comparing something like a 12AX7 loaded with a 100K resistor against something like a 6C45PI with an active load, each stage will sound very different.
If you like some extra distortion from your driver stage, then stick with the low transconductance tubes with less than ideal loads.
If you want a reasonably transparent driver stage for your DHT finals, these tubes are nice choices.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I 2nd This - Caucasian Blackplate 09:39:47 03/30/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
