|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Chassis Source other than Hammond or Par Metal. posted by drlowmu on January 23, 2013 at 19:03:58:
H Jeff,
I will be doing something similar for my second build, but hopefully in non-magnetic stainless. I will have the fabricator cut the large holes for me, though I should have some SEK holesaws soon, which supposedly leave a very round hole (I have access to decent drill press).
I have a link somewhere of an online US firm the can do all sorts of small fabrication work, chassis and machining etc. You just use their software to do the design, send it, and they do the rest. No, it's not FPE. Being Aus, I will use someone local - just thought I'd mention it.
Cheers.
"In the beginner's mind there are many possibilities, in the expert's mind there are few." Shunryo Suzuki
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Chassis Source other than Hammond or Par Metal. - RC Daniel 23:28:03 01/25/13 (2)
- RE: Chassis Source other than Hammond or Par Metal. - drlowmu 08:54:44 01/27/13 (1)
- RE: Chassis Source other than Hammond or Par Metal. - RC Daniel 22:59:16 01/28/13 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
