Home Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Tube DIY Asylum ]
[ Alert Moderator ]

RE: Schottky diode for cathode bias

Paul, I do seem to recall a higher figure than o.4 ohms however I got the figure from a simple curve tracer Sim I did to look at some alternatives for cathode bias following the long discussion regarding battery bias recently. I assume the models are accurate.

I looked at many different parts including LEDs and some of the findings surprised me. I was going to post these but had to travel interstate so decided to wait until I got back and look at things in greater detail. Will do so soon to see if anyone picks up on something I may have missed.

Naz

This post is made possible by the generous support of people like you and our sponsors:
  MagneQuest Transformers   [ MagneQuest Forum ]

Follow Ups Full Thread
Follow Ups
  • RE: Schottky diode for cathode bias - Naz 07:01:11 06/20/12 (0)
FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2013, Audio Asylum, all rights reserved ] [ Take5 ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]