|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: questions on a new design posted by DanK tubes on September 10, 2009 at 21:12:21:
You're dropping 145VDC across the source pin R on the CCS, so you'll be dissing about what?.... 5.1 Watts...?
...to be safe you'll need a 10W R before the CCS to ease some of the dissipation burden off it and drop the VDC to a more tolerable level...
as has been suggested to me before by the the wise mages on this site, a Mills 12W should fit the bill just fine...
slownlo
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: questions on a new design - slownlo 07:15:47 09/11/09 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
