Tube DIY Asylum

RE: Eagle pcb

67.164.79.218

In Reply to: RE: Eagle pcb posted by nc on May 10, 2008 at 14:54:12

An old version of one of the power supplies was done as a board with Eagle, it doesn't match the current design though, its been modified since then. The other supply I started from a Gary Pimm board and modified it. The heater supply and cascode board were hand wired on perfboard. The tubes were point to point wired on a separate suspended sub-chassis.

I suppose I could do all or part of the design as a board if there is enough interest. I like laying out boards and these are pretty easy. Would people like the tube sockets on the boards or have the boards separate and wire then to the tube sockets?

John S.

Follow Ups:

RE: Eagle pcb - nc 18:07:56 05/10/08 (5)
- RE: Eagle pcb - jkeny 16:59:59 05/15/08 (4)
  - RE: Eagle pcb - John Swenson 16:10:52 05/16/08 (2)
    - RE: Eagle pcb - jkeny 19:15:56 05/17/08 (1)
      - RE: Eagle pcb - jkeny 04:46:04 05/18/08 (0)
  - RE: Eagle pcb - jkeny 17:02:36 05/15/08 (0)

Post a Followup:

FAQ

Post a Message!

Forgot Password?

Moniker (Username):
Password (Optional):
	Remember my Moniker & Password (What's this?) Eat Me
E-Mail (Optional):
Subject:

Message:	(Posts are subject to Content Rules)

Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:	Automagically notify you when someone responds.

To view your new posting or follow-up, click on the RELOAD or REFRESH button on your browser.