|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: tx-rectifiers-lclc-cmc-hum pot-filaments posted by nc on April 6, 2007 at 12:48:53:
The critical value for the input choke is about 6 mH, but it should be rated 9 A. The second choke has to be rated only 3 A, so its value can be higher than 10 mH. 50 mH 3 A choke with 1-2 Ohm DCR has a reasonable size. CMC is easy as it does not need a gap. Cap values are right, but they may be higher than 10,000 uF. A tuned snubber circuit for bridge rectifier would be also helpful to keep the line clean.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Right. - sser2 13:23:15 04/06/07 (2)
- More research & an article by Lynn Olson - nc 14:14:00 04/07/07 (1)
- Sure it won't hurt to have more. - sser2 16:46:26 04/07/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
