|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Filament bias and PP DHT posted by fatbottle on January 26, 2007 at 01:02:14:
A couple of things I would change. Since you're using DC heating, it makes no sense in adding hum bucking pots on each side. I would replace the pots with fixed resistors - a pair of 10 ohms on each side would be okay and then take the signal from the center of those.Next for balance control I would add just one pot - the wiper would go to the center resistor that heads to ground. Each other end would go to the common connection of those 10 ohm fixed resistors on each 46. I don't know what value would be best for that one pot, but it shouldn't need to be too big.
Kurt
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Filament bias and PP DHT - kurt s 08:15:05 01/26/07 (5)
- Yes, the pots are put in the wrong place. - cheap-Jack 08:26:41 01/26/07 (1)
- Re: Yes, the pots are put in the wrong place. - fatbottle 08:42:45 01/26/07 (0)
- Re: Filament bias and PP DHT - fatbottle 08:23:20 01/26/07 (2)
- I'd opt for the LL1635/5ma or perhaps the /20 - arend-jan 09:12:50 01/26/07 (1)
- Re: I'd opt for the LL1635/5ma or perhaps the /20 - fatbottle 10:59:56 01/26/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
