Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders.

---

[ Follow Ups ] Thread: [ Display  All  Email ] [ Tube DIY Asylum ]

---

[ Alert Moderator ]

---

What would you do with this Iron?

Posted by Chris v.W. (A) on May 16, 2006 at 12:43:10

Hi Everyone,

I received some nice Sansui iron from a friend. The OPTs are the same as used in the AU-111. I measured 4K primaries, no UL taps. The secondaries are 16/8 Ohm. It has another secondary winding that is connected to the cathodes. Presumably for NFB.

The AU-111 used 6L6GC's. I'm considering using KT88's.

The PSU trafo is not from an AU-111. It has 0-220-230V primaries. Secondaries are: 0-330V, 0-330V, 0-87V, 13-0-13V, 0-6.3V. VA rating is unknown. My friend seems to remember that it had two pairs of EL34s per channel.

What do you guys recommend I build with this Iron? Any advice will be much appreciated.

Chris

• AU-111 OPT Schematic   (Open in New Window)

This post is made possible by the generous support of people like you and our sponsors:

Sonic Craft

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---