I hooked up according to the base diagram. it is taking the place of a section of 6sn7. B+ is 300. Plate resistor 80k , Cathode resistor is 360 ohms. Filament voltage is 6.4vac. I am using it as a driver tube.
I put signal on G1 and get nothing. I just did the same circuit with a 6j5 with no problems
Edits: 01/06/17
This post is made possible by the generous support of people like you and our sponsors:
Topic - Is there a secret to using the 7A4? - DAK 20:34:25 01/06/17 (18)
- RE: Is there a secret to using the 7A4? - Tre' 11:20:06 01/07/17 (13)
- If i use a Blue LED ? - DAK 15:05:15 01/07/17 (0)
- RE:Actually, i had a circuit problem. But, your suggestion is good - DAK 14:39:33 01/07/17 (11)
- RE:Actually, i had a circuit problem. But, your suggestion is good - Tre' 18:52:17 01/07/17 (10)
- I'm open to suggestions and a CCS would be something i'd like to try - DAK 19:47:44 01/07/17 (9)
- RE: I'm open to suggestions and a CCS would be something i'd like to try - Tre' 08:08:07 01/08/17 (8)
- RE:I changed the plate resistor between posts - DAK 08:38:55 01/08/17 (7)
- RE:I changed the plate resistor between posts - Tre' 17:33:29 01/08/17 (6)
- RE:I changed the plate resistor between posts - DAK 19:57:30 01/08/17 (5)
- RE:I changed the plate resistor between posts - Tre' 09:41:04 01/09/17 (4)
- Do you know someone who makes one that i can buy? - DAK 09:56:01 01/09/17 (3)
- RE: Do you know someone who makes one that i can buy? - Tre' 14:54:26 01/09/17 (2)
- RE: Do you know someone who makes one that i can buy? - DAK 15:27:19 01/09/17 (1)
- RE: Do you know someone who makes one that i can buy? - Tre' 16:20:12 01/09/17 (0)
- You do know it's a different pinout? - andy evans 04:04:05 01/07/17 (3)
- RE: what about the central locator pin? - DAK 08:17:29 01/07/17 (2)
- RE: what about the central locator pin? - maxhifi 11:06:28 01/07/17 (1)
- Ok, thank you , nt. - DAK 14:41:41 01/07/17 (0)