In Reply to: RE: Really? posted by Triode_Kingdom on July 8, 2015 at 11:29:38:
With 10k ohms reflected you will need 80Hy to have a inductance reactance of 10k ohms at 20Hz giving you a -3db point of 20Hz and a load line for that frequency that's not optimum.
You would need 160Hy to get 20Hz at -1db.
Even then the load line would not be totally optimum.
Your damping factor, about 3k ohms plate resistance into 10k reflected//the reactance of the inductance at the low frequencies, might not be enough for every speaker.
In the presents of frequencies that cause the load line to become an ellipse, do to the low reactance of the "less than really needed" inductance, all the frequencies follow the elliptical load line and that adds distortion to everything.
How much primary inductance does the FS-100 have?
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Really? - Tre' 12:22:37 07/08/15 (16)
- RE: Really? - dave slagle 21:32:37 07/08/15 (14)
- You're right, I'm wrong. - Tre' 08:17:08 07/09/15 (13)
- RE: You're right, I'm wrong. - dave slagle 09:15:18 07/09/15 (12)
- RE: You're right, I'm wrong. - Tre' 10:08:12 07/09/15 (11)
- RE: You're right, I'm wrong. - dave slagle 16:08:40 07/09/15 (10)
- RE: You're right, I'm wrong. - Tre' 17:03:38 07/09/15 (9)
- RE: You're right, I'm wrong. - dave slagle 06:58:44 07/10/15 (8)
- RE: You're right, I'm wrong. - Tre' 07:50:07 07/10/15 (7)
- RE: You're right, I'm wrong. - dave slagle 13:09:49 07/10/15 (6)
- RE: You're right, I'm wrong. - Tre' 15:39:36 07/10/15 (5)
- RE: You're right, I'm wrong. - dave slagle 07:27:20 07/13/15 (3)
- Nice work Dave ... - Naz 07:09:53 07/18/15 (2)
- RE: Nice work Dave ... - dave slagle 09:00:40 07/20/15 (1)
- Ahh, I remember it now, thanks (nt) - Naz 04:21:35 07/21/15 (0)
- Operating Impedance - Triode_Kingdom 19:34:33 07/10/15 (0)
- RE: Really? - Paul Joppa 14:34:18 07/08/15 (0)