Home SET Asylum

Single Ended Triodes (SETs), the ultimate tube lovers dream.

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ SET Asylum ]
[ Alert Moderator ]

Slight change in power supply cap value - problem ??




Hello,

Since this is my first project, I am trying to stick to the schematic pretty strictly (figure that is a good thing, since I am learning as I go). I decided to use a different option on the layout, and that calls out a slightly lower capacitance value in the high voltage supply - 2x200uf @ 500v vs 2x 220uf @ 500v. I assume that this not a problem, and from a post here, it sounds like putting it after the choke would be the optimal spot for it. The 2x220uf is one of the few caps I already have, so I hesitate to exclude it if there is no issue.

Please let me know.

Regards -- Roger

This post is made possible by the generous support of people like you and our sponsors:
  Kimber Kable  

Topic - Slight change in power supply cap value - problem ?? - rogerh113 16:00:24 06/15/15 (20)
FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]