Home SET Asylum

Single Ended Triodes (SETs), the ultimate tube lovers dream.

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ SET Asylum ]
[ Alert Moderator ]

RE: Socket Mounting







Hello,

The sockets were acquired by the initiator/prior owner of the project, and I don't have a clue as to the style/maker.... I have however attached a couple of pictures that will hopefully tell all!!

The upper surface, to which the 1/2" tube would butt, is indeed glazed. I put my small straight edge flat across the glazed base mounting hole, and it does look as though is pretty much perpendicular to the brass cylinder (excuse me for not knowing the proper terminology). I was planning on using a fibre washer (or felt) between the tube and the ceramic as well as the tube and bottom of plate (good buffer to prevent vibration and provides a bit of friction to keep the Al tube from rotating).

Regards -- Roger

This post is made possible by the generous support of people like you and our sponsors:
  Kimber Kable  

Follow Ups Full Thread
Follow Ups
FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]