Home SET Asylum

Single Ended Triodes (SETs), the ultimate tube lovers dream.

RE: Mills MRB-12 failure

There is one thing that may have caused the failure. There is a fat Mogami signal cable that runs from the back of the amp to the input pin of the tube, past those resistors. The insulation of that cable at one point was touching that 20k resistor as it is apparent from the burn marks on the cable. It is possible that PVC material somehow penetrated the silicon skin of the resistor and managed to "incinerate" the resistive element or contaminate the end cap causing the resistor to fail.

Usually when resistor burns you can definitely tell that it had burned, the visuals should be there. In my case the resistor looks perfectly normal, no cracks, spots, discoloration or smell. Need to do a detailed autopsy. Mystery!


This post is made possible by the generous support of people like you and our sponsors:
  Amplified Parts  


Follow Ups Full Thread
Follow Ups
  • RE: Mills MRB-12 failure - Abacus Music 11:05:41 03/08/15 (0)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.